The belt clamp is used for pulling the conveyor belt in order to make there is certain distance between the two ends of the conveyor belts. That’s convenient for make the joint. The belt clamp is a ideal tool to pulling various kinds of belts.
2. Structure
The belt clamp is composed of clamp and pressing pole.
The structure of the belt clamp is simple, the six connecting poles connected to each other to make a circle. Its pressure to the pressing pole is increasing according to the pulling force. The pressing pole is made of high tensile aluminum alloy rectangular tube. It can average the pressure in the whole pressing pole and has a dependable clamp function. There are several triangle type teeth located in the surface which is contact to belt, it will snap-in without movement in condition of there is a pressure.
3. Product Scheme
Picture 1. General Drawing of Product
1. SteelPin2.Clamp3. Dischargeloop4. Steelcord5. Fixing unit 6. Hook7. Pressing pole 8. Conveyor belt
4. Technical Parameter
Specification
Maximum suitable belt
width(in)
Belt thickness range
(mm)
Belt Clamp 36”
36
10-22
Belt Clamp 42”
42
10-22
Belt Clamp 48”
48
10-22
Belt Clamp 60”
60
10-22
5. Use
1) Put a couple of pressing poles in a certain distance to the belt end, the teeth surface
should contact to the conveyor belt in both upper and bottom surface of the belt. (See
picture 3)
2) Make a couple of clamps get through of each end of the pressing poles and close to the
conveyor belt. Adjust the position of two pressing poles in order to let the steel pins get
through. And make the two steel pins get through. (See Picture 1, Picture 2)
3) Process the same application in the other end the belt.
4) The two hook of the fixing unit is connected to the discharge loop of the clamp.
5) Operate on the both fixing units at same time, make the hook tends to the fixing unit
direction tightly. The clamp will bring the conveyor belt moving to the required position by
the function of pulling force.
6) Make joint or process other related operation.
7) Loose the fixing unit. Finished.
6. Maintenance
1) The belt clamp can only sustain the parallel force, otherwise it is easy to be damaged. Thus,
please keep the clamp and pressing poles parallel as much as it can in the operation process.
2) Don’t hammer the clamp and pressing poles in order to prevent distortion.
3) Please put the belt clamp back to the packing cartons when the operation is finished.